By Jean-Eudes Ambroise
How to choose the right VoIP gateway?
Once we know what a VoIP gateway is, we can determine and test the gateway suited to the end client’s needs.
To simplify matters, we can rely on the most frequently encountered scenarios:
- Connect an RTC line to an IPBX
- Connect analog terminals to an IPBX
- Migrate to a VoIP solution
- Connect a traditional PBX to a SIP trunk
Once the scenario is identified and the number of required ports known, you can use the beroNet configurator to determine the suitable model
Connect an RTC line to an IPBX
Here, the client has a traditional communication system that is not compatible with VoIP: it may be analog lines or RNIS lines. They want to connect this same system to an IPBX that is not compatible with the RTC.
RNIS linesOne thing is certain, the end customer here needs an RNIS gateway. If they also have analog lines, see the following section. In terms of RNIS, two types of lines are distinguished: BRI /T0 (basic access) and PRI / T2 (primary access, also called E1 in Europe and T1 in the United States).
- A BRI/T0 line allows up to 2 simultaneous calls,
- A PRI/T2 line allows up to 30 simultaneous calls.
By taking into account the number of RNIS lines the client has, we get an idea of the number of simultaneous calls they can make.
Example:
- If it can handle 8 simultaneous calls, it probably has 4 T0 lines. A 4T0 gateway would then be required.
- If the customer has 2 T2 lines, a 2 T2 gateway will be required
To connect an analog line to an IPBX, an FXO gateway will be required. Since an analog line allows only one call at a time, determining the number of required ports will be relatively simple.
Connect analog terminals to an IPBX
To recover analog terminals and connect them to an IPBX, an FXS gateway is used. The number of required ports will depend on the number of terminals to connect.
Here are some examples of terminals that can be connected to an IPBX via a VoIP gateway:
- analog phones
- fax
- doorbell
- payment terminals
- alarm systems
If you wish to connect other analog equipment, contact us to verify its compatibility.
Using the beroNet hybrid module, it is possible to connect 2 analog terminals and 2 T0 lines to an IPBX.
Flexible migration
During a flexible migration, a traditional PBX, an IPBX, or even RTC lines will generally be connected to the gateway. Again, the technology used in the gateway will depend on that used by the PBX:
- RNIS: beroNet RNIS gateways can operate in NT mode or TE mode, allowing the gateway to simulate the RNIS operator or the PBX. If the PBX used during the flexible migration is a digital PBX, it will be necessary to determine which types of lines it is connected to (BRI/T0 or PRI/T2). Once the type and number of connected lines are known, the appropriate gateway model is known. Example: if the PBX has a PRI/T2, a 2T2 gateway will be required (one port will be used in each direction).
- Analog: here, a gateway equipped with FXO and/or FXS ports will be required: an operator line will connect to the FXO ports while a PBX will connect to the gateway’s FXS ports. It will simply be necessary to know the number of required ports.
